The unique features of the salt spray test chamber, allows you better observation and access to your corrosion testing. The construction is made of high-quality Lucite®️ plexiglass on five sides making it the only 360-degree view into the chamber workspace.
Completely self-contained, the MX Series salt spray chambers allow for test items to be subjected to a corrosive environment without introducing other contaminants into the test area.
STANDARDS. The standard MX-9232 salt spray test chamber has an atomizing nozzle that can be factory set to be compliant with the following standards:
HEATING SYSTEM. To ensure temperature uniformity in the test workspace, the unit uses two separate RTD sensors. One for holding and conditioning incoming water to an accurate 45.5°C (113.9°F). As the water is mixed with the salt solution and atomized the temperature falls. In the product workspace, a second RTD sensor holds the ambient temperature at a steady 35°C (95°F) as the fog fills the workspace.
Salt Spray chambers are commonly used to evaluate the corrosive properties of:
INSTRUMENTATION. The standard MX corrosion test chambers have two independent manual-set digital controllers ensuring the heated water being sprayed and the workspace air temperature are controlled to the desired setpoint.
For capturing temperature readings in both areas throughout your test cycle, upgrade your controller to access AESONE CONNECT. Learn more.
EXTENDED TESTING HOURS. For longer testing that extends beyond 70 hours, consider adding an optional Salt Spray Water Recycling Package that can extend the length of your tests to 144 hours.
| Interior: | 60W x 30D x 30H (in) |
| 152.5W x 76D x 76H (mm) | |
| Exterior: | 92.5"W x 38.5"D x 51"H (in) |
| 2349.5W x 977.9D x 1295.4H (cm) | |
| Volume: | 31.25 cubic ft |
| 884.91 liters | |
| Electrical Supply: | 208VAC or 230VAC, 1PH, 60HZ, |
| Full Load Amps: | 12 |
| Power Requirement: |
NEMA L6-20
|
| Mobility: | Will fit through 48" door |
Temperature and Humidity are manually-set with two Watlow EZ-ZONE PM controllers (non-programable). Push-button controller with segmented displays. Has optional RS-232 or RS-485 serial communication.
Upgrade to: AESONE CONNECT creating a robust connected device for a standard and uniform interface making test chamber operation easier.
AESONE XCHANGE increases your functionality
AESONE SOFTWARE gives you the power to
WATLOW F4T PROGRAMMABLE CONTROLLER. Features a 4.3” capacitive touchscreen minimizing the chance for error. Ethernet communication supported by AESONE HARDWARE. View more controller options
SENSORS. 100 OHM Platinum RTD is a highly-accurate sensor made from platinum components for increased sensitivity View sensor options
OPTIONAL DATA LOGGERS. View additional data loggers
Internal Thermal Heat Fuse - interrupts flow of electricity if it reaches a preset temperature
