How to Set Up a Profile on AESONE CONSOLE

This article will take you step by step on how to create a profile on AESONE CONSOLE.

How to Create a Profile On AESONE CONSOLE.

Step 1:

When opening up your AESONE CONSOLE, you will see your dashboard. Navigate to the Play/Pause Icon named "Profile Control".

Screen Shot 2023-06-08 at 2.55.38 PM

Step 2:

Click on the   icon, which opens up a dialog box for creating a new profile.

Screen Shot 2023-06-08 at 2.56.02 PM

Step 3:

Give your profile a name and input your temperature and/or humidity setpoints. Click Ok when done.

*For your temperature setpoints and/or humidity setpoints, please refer to your original quote provided by your sales representative. 

Screen Shot 2023-06-08 at 2.59.23 PM

You have successfully created a profile and can view it under your "Profile Control" icon.

Screen Shot 2023-06-08 at 2.59.56 PM

How to Import a Profile on AESONE CONSOLE.

Step 1:

Navigate to the right hand corner and select the Import icon.

Screen Shot 2023-06-08 at 3.01.13 PM

Step 2:

A dialog box will appear, allowing for the selection of a JSON profile. Rename the imported profile and click “import” to load it onto your device.

What are the different types of steps you can use to build your profile?

Step Types

This section will provide an overview of the five different step types that make up a profile. As steps are added to a profile, they are displayed in the Profile Steps Table. Each step type has its corresponding icon shown on the left-hand side of the step row. 

NOTE: All step types require the user to specific event states, “on,” “off,” or “unchanged”. 

Add Step: Allows the user to select one of the five steps supported

Soak:  Maintains a set point over a set period of time.

Wait For: Waits for certain conditions to be met before moving on to the next step.

Ramp:  Control to a specific set point.

Ramp Time: Reach your target set point over a set duration.

Ramp Rate: Reach your target set point at a specified rate. Ramp Instant: Instantly start controlling at your target set point.

Jump: Jump to a specific step and repeat all other steps to the jump step a specific number of times. For example, if a jump step is number 5 in the profile and is set to jump to step 1 and repeat three times. It will run through steps 1-5 four times before moving to step 6.

End Step: Set control conditions that are implemented on profile completion. 

End Type User: Sets the setpoint back to what its original value was prior to having a profile run.

End Type Off:  Turns the loop off after the profile finishes running.

End Type Hold:  Maintain the current set point.

If you have any questions, please reach out to support: or call