The BD-104 Model is a liquid-cooled laboratory oven capable of providing highly-stable, controlled, forced hot air circulation with rapid cooling using liquid LN2 or CO2.
BD-100 Model Laboratory Ovens provide dry, air-circulated heat as an environmental testing condition. The ability to maintain precise temperatures occur with help from direct, drive-powered fans.
CONSTRUCTION. These liquid-cooled laboratory ovens feature a durable powder-coat finish over heavy-gauge steel, with stainless steel internal construction, and highly-efficient, low K factor, thermal insulation, this is built to last for many years.
CIRCULATION SYSTEM. The performance level operates the internal workspace temperature from approximately -73°C to +220°C (approximately -100.4°F to +428°F).
HEATING SYSTEM. The oven features an industry-leading heating system equipped with low-watt density, ceramic core, nichrome heaters for accurate temperatures within ±0.5°C, as measured at the sensor.
RAPID COOLING. Liquid cooling will bring a hot oven down to ambient conditions and as low as -73°C (-100°F) in just a couple of minutes. Pull-down rates for the liquid cooling process are much faster than traditional test chamber mechanical refrigeration.
CRYOGENIC COOLING. To get temperatures to a cryogenic level, BD-104 laboratory ovens are customizable with a liquid LN2 or CO2 boost cooling option. This option allows the test chamber to reach a low of -185°C and a high of 260°C (-300°F to +500°F). Due to configuration changes, sizing may be different than shown in the basic specifications below.
BD Series Laboratory Ovens are ideal for:
If rapid cooling is not a requirement, take a look at the BD-900 Models.
INSTRUMENTATION. The standard BD models have a manual-set digital controller. For more sophisticated test profiles, upgrade incorporates AESONE CONNECT creating a robust connected device giving you a standard and uniform interface that makes operation easier. Learn more in the Instrumentation Tab below.
|Interior:||18W x 18D x 22H (in)|
|457.2W x 457.2D x 558.8H (mm)|
|Exterior:||24.5W x 26.4D x 38H (in)|
|622.3W x 670.56D x 965.2H (mm)|
|Volume:||4.13 cubic ft|
|Temperature:||-73°C to 220°C (-99.4°F to 428°F)|
|Pull Down Rate*:||8°C/minute|
|Electrical Supply:||120VAC, 1PH, 60HZ,|
|Full Load Amps:||22A|
|Power Requirement:||NEMA L5-30|
|Mobility:||Will fit through 32" door|
*Rise and pull-down rates calculated using IEC 60068-3-5 standard. Custom options available.
Temperature is manually-set with one Watlow EZ-ZONE PM controller (non-programmable)
BD Series Test Chambers can incorporate AESONE CONNECT creating a robust connected device for a standard and uniform interface making test chamber operation easier.
AESONE XCHANGE increases your functionality
AESONE SOFTWARE gives you the power to
WATLOW F4T PROGRAMMABLE CONTROLLER. Features a 4.3” capacitive touchscreen minimizing the chance for error. Ethernet communication supported by AESONE HARDWARE. View more controller options
HIGH/LOW TEMPERATURE CONTROL. An adjustable temperature limit controller allows you to program the highest lowest temperature the device under test, protecting products from compromising temperature exposure.